Lab37. Frame Relay Multipoint Subinterface – Static Mapping

080913_1152_FrameRelayI1.pngObjective
Pada lab sebelumnya kita belajar dynamic mapping subinterface, kali ini kita  belajar static mapping pada subinterface

Metode Lab

  • Hapus konfigurasi dynamic mapping pada konfigurasi sebelumnya
  • Konfigurasikan static mapping

Verifikasi Lab
Pastikan frame relay mapping STATIC muncul pada subinterfacenya.

Rubah dari dynamic mapping menjadi static mapping
RM-R1(config-subif)#int s0/0.1 multipoint
RM-R1(config-subif)#no frame-relay interface-dlci 102
RM-R1(config-subif)#frame-relay map ip 12.12.12.2 102 broadcast

RM-R2(config)#int s0/0.1 multipoint
RM-R2(config-subif)#no frame-relay interface-dlci 201
RM-R2(config-subif)#frame-relay map ip 12.12.12.1 201 broadcast

Cek mappingnya
RM-R1(config-subif)#do sh frame-relay map
Serial0/0.1 (up): ip 12.12.12.2 dlci 102(0x66,0x1860), static,
              broadcast,
              CISCO, status defined, active

RM-R2(config-subif)#do sh frame-relay map
Serial0/0.1 (up): ip 12.12.12.1 dlci 201(0xC9,0x3090), static,
              broadcast,
              CISCO, status defined, active

Pastikan masih bisa ping
RM-R2(config-subif)#do ping 12.12.12.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 12.12.12.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 12/90/196 ms
RM-R2(config-subif)#

Tinggalkan Balasan

Isikan data di bawah atau klik salah satu ikon untuk log in:

Logo WordPress.com

You are commenting using your WordPress.com account. Logout / Ubah )

Gambar Twitter

You are commenting using your Twitter account. Logout / Ubah )

Foto Facebook

You are commenting using your Facebook account. Logout / Ubah )

Foto Google+

You are commenting using your Google+ account. Logout / Ubah )

Connecting to %s